Function configuration
The Function menu contains the following menu items:
Console configuration
Updating console software.
Select: System/ Functions/ Console.
Updating the console software
This function is used if the console software is updated from a USB device.
Connect the USB device containing the software update. When this option is selected, a message is displayed notifying that the console will be rebooted. Confirm the message. The console is rebooted and the software update is loaded.
The console asks if the user wants to restore all user data to the state prior to the update. Note: If No is selected, all data saved on the console will be deleted.
Guidance system configuration
Configures the functions of the guidance system. To configure the guidance system functions:
- Select: System/ Functions/ Guidance.
Help
Standard function of console, which cannot be disabled.
Autosteer
Enables autosteer function and may only be used on vehicles equipped with an autosteer system.
Guidelines (AB lines, identical curves etc.)
The four guideline types (AB lines, identical curves, pivots and guidelock) are all enabled by default. Unnecessary guideline types may be disabled. However, all guideline types cannot be disabled simultaneously.
Implement setup
Configures functions for the attached implement. To configure the implement functions, select: System / Functions / Implement.
Automatic section control
This function allows the system to activate sections for new work areas to be covered and to deactivate sections for areas that have already been covered.
Locks settings menu when master switch is on
Disables access to settings menu when master switch is ON.